When a latched button is pressed, it changes from state 0 to state 1 and writes the state 1 value to the Value control tag. Using "Latch reset type:" = " Non-zero Value": Yours is set to the default "Non-zero value". This can be "Non-zero Value" or "Zero to Non-zero transition". To determine how the Handshake control tag unlatches the button, under the "General" tab you select which type of reset, or unlatch, you require for the latched button. the Value control tag, you must use the Handshake control tag to do so. When you want to unlatch the button, i.e. When you press a latched button it changes from the unlatched state 0 to latched state 1 and writes the state 1 value, default = 1, to the Value control tag. I'll explain how the Handshake control works for a latched button. You have assigned the same tag, " HMI_Test_2\FT_Greifer", to both the Value and Handshake control tags. But, you MUST create a separate Handshake control tag. Ok, OG got there before me but that's what I was wondering as well, you had no Handshake control tag assigned.Īs OG mentioned, you MUST use the Handshake to unlatch the button back to state 0. (Because of the Handshake I think) How can I use them without that they reset themselves?Īs information: I took latched push buttons so it should work. But if I set them they reset themselves after some seconds.
0 Comments
Leave a Reply. |